SRAM UDH Dropout Bushing, Stainless, 1.0mm Eccentric

Material: 303 stainless steel (identified by a dot on the smaller OD collar)

Style: Eccentric, 1.0 mm

• Four 2.2 mm radial holes on the flange
• Single identification groove on the 24 mm diameter
• Use a 2 mm hex key to rotate the insert, using the radial holes on the flange

Application:

• Fits into the right frame component of our stainless steel SRAM Full Mount/UDH eccentric round, rear dropouts
• Allows for fine tuning wheel alignment in the frame following frame construction
• The bushing:
  • Must be silver brazed in
  • Once installed, is not meant to be consumer serviced
  • Is a structural part of the assembly